Updated Nov 16, 2026· 5 min read

Key takeaways

  • Desktop PCs: check that both antennas are screwed onto the card or motherboard connectors and positioned in open space, not behind the case.
  • Move the router off the floor and away from metal, thick walls and other electronics.
  • USB Wi-Fi dongles sitting in rear ports next to fast USB devices can suffer interference; an extension cable can help.
  • Powered-off PC and unplugged before opening the case. Do not open the power supply.

The fastest fix for Wi-Fi that keeps dropping is to restart the router and PC, then turn off power saving for the wireless adapter in Device Manager and move to the 5 GHz band or a less crowded router channel. If it still drops, the cause is usually a driver, signal strength or interference problem, and the steps below go from quick to thorough.

Quick reference: symptom, likely cause, fix

Symptom Common cause First fix
Drops every few minutes on one device only Adapter power saving or outdated driver Set adapter to maximum performance and update the driver
All devices drop at the same time Router or modem fault, or provider outage Power cycle the modem and router
Drops far from the router Weak signal, walls Move closer or use a mesh node or wired access point
Drops in the evening Channel congestion from neighbours Change channel or band in router settings
Drops after waking from sleep Power management for the adapter Disable the option that lets the PC turn the device off
Connected but no internet DNS or IP configuration problem Run the Windows network troubleshooter and reset commands

Step 1: find out whether it is the PC or the network

Test another device in the same room. If a phone also loses the connection, the router, modem or internet service is the likely source. If only your PC drops, focus on the adapter, driver and Windows settings. This one check saves a lot of unnecessary reinstalling.

Step 2: restart in the right order

  1. Shut down the PC.
  2. Switch off and unplug the modem and router. Wait at least 30 seconds, as Microsoft’s Wi-Fi help advises when power cycling.
  3. Plug in the modem first, let it settle, then the router.
  4. Start the PC and reconnect.

Step 3: turn off adapter power saving

Microsoft’s guidance for frequent drops lists adjusting power settings so the wireless adapter runs in maximum performance mode, and disabling power saving for the adapter in Device Manager. Laptops are especially prone, since the system is allowed to switch the radio off to save battery.

  1. Open Device Manager and expand Network adapters.
  2. Open the properties of your Wi-Fi adapter.
  3. On the Power Management tab, clear the option that lets the computer turn off the device to save power.
  4. In the Windows power plan’s advanced settings, set the wireless adapter setting to maximum performance.

Exact labels vary between Windows versions and adapter makers.

Step 4: update or reinstall the driver

An outdated or damaged driver is a classic cause of random disconnects. Install the latest system and driver updates through Windows Update first. If that does not help, uninstall the adapter in Device Manager and restart so Windows reinstalls it. Alternatively, download the driver from the maker of the adapter, or from the laptop or motherboard maker, who often supply a tuned version. Note that a very new driver can occasionally introduce a fault, so if drops began right after an update, rolling back is a valid test.

Step 5: change band or channel

Microsoft suggests switching between 2.4 GHz and 5 GHz if your router offers both, and changing the router channel in its admin page to reduce interference. The two bands trade off differently.

Band Strengths Weaknesses
2.4 GHz Better range and wall penetration Crowded by neighbours, microwaves and Bluetooth devices
5 GHz Less crowded, faster at moderate distance Shorter range through walls
6 GHz (Wi-Fi 6E and Wi-Fi 7 hardware) Even more free spectrum Shortest range; needs support in router and PC

If your router uses one name for both bands, give each its own name temporarily so you can choose which one your PC joins. Menu names differ by router brand, so use its manual.

Step 6: reset the network stack

Microsoft lists network commands such as winsock reset, renewing the IP configuration and flushing the DNS cache. Use Command Prompt as administrator and follow Microsoft’s support page for the exact commands. As a last resort, the Network reset option in Windows settings reinstalls adapters with default settings. It also removes saved networks and VPN settings, so note your Wi-Fi password first.

Step 7: look at the physical side

  • Desktop PCs: check that both antennas are screwed onto the card or motherboard connectors and positioned in open space, not behind the case.
  • Move the router off the floor and away from metal, thick walls and other electronics.
  • USB Wi-Fi dongles sitting in rear ports next to fast USB devices can suffer interference; an extension cable can help.
  • Powered-off PC and unplugged before opening the case. Do not open the power supply.

When to stop troubleshooting the PC

If every device loses the connection at the same time, contact the internet provider or check for an outage. If the router is several years old and drops regularly, ask the maker about a firmware update or replacement. For a PC that still drops after everything above, a wired Ethernet connection is the dependable alternative, especially for gaming, and a faulty adapter should go to the maker or a technician for warranty service.

Common mistakes

  • Reinstalling Windows before checking whether other devices drop too.
  • Leaving the router on automatic channel selection that keeps moving to a bad channel, when a fixed less-used one would be steadier.
  • Using range extenders that repeat a weak signal instead of placing a node where the signal is still strong.
  • Installing driver-updater utilities of unknown origin rather than the maker’s own drivers.

Frequently Asked Questions

Why does my Wi-Fi disconnect when my PC wakes from sleep?

Windows may have switched the adapter off to save power. Clearing the option that lets the computer turn the device off in the adapter’s power settings, and updating the driver, usually helps.

Is 5 GHz or 2.4 GHz better for stability?

5 GHz is generally less crowded, so it often drops less when you are near the router. 2.4 GHz reaches further through walls. Choose based on distance and the interference at your home.

Can a bad router cause disconnects on only one device?

It can, if that device is far away or uses an older wireless standard, but a single-device problem more often points to the adapter, driver or power settings.

Should I use the network reset option?

Only after simpler steps fail. It reinstalls network adapters and restores defaults, which clears saved networks and VPN configurations, so you will need to set those up again.

Would a wired connection fix it?

It removes radio interference from the equation. If a cable is stable and Wi-Fi is not, the problem is in the wireless link rather than your internet service.

When is it a hardware fault?

If the adapter vanishes from Device Manager, drops on every network, or still fails after a clean driver install, contact the maker or a technician. Hardware repairs should not be attempted inside a power supply or on soldered components.

A
Aiden Cooper
We compare specs, materials and verified owner reviews before a product earns a spot. Rankings are never paid.

FAQ

Why does my Wi-Fi disconnect when my PC wakes from sleep?
Windows may have switched the adapter off to save power. Clearing the option that lets the computer turn the device off in the adapter’s power settings, and updating the driver, usually helps.
Is 5 GHz or 2.4 GHz better for stability?
5 GHz is generally less crowded, so it often drops less when you are near the router. 2.4 GHz reaches further through walls. Choose based on distance and the interference at your home.
Can a bad router cause disconnects on only one device?
It can, if that device is far away or uses an older wireless standard, but a single-device problem more often points to the adapter, driver or power settings.
Should I use the network reset option?
Only after simpler steps fail. It reinstalls network adapters and restores defaults, which clears saved networks and VPN configurations, so you will need to set those up again.
Would a wired connection fix it?
It removes radio interference from the equation. If a cable is stable and Wi-Fi is not, the problem is in the wireless link rather than your internet service.
When is it a hardware fault?
If the adapter vanishes from Device Manager, drops on every network, or still fails after a clean driver install, contact the maker or a technician. Hardware repairs should not be attempted inside a power supply or on soldered components.
Affiliate disclosure. As an Amazon Associate we earn from qualifying purchases at no extra cost to you. Prices accurate as of the date shown.

More from Amazon

Programs that pair well with the guide above. Offers and eligibility are set by Amazon and may change.

Amazon Prime

Free shipping on eligible items, Prime Video and more. Eligible new members can start with a free trial.

Start a Prime free trial
Amazon Music Unlimited

Ad-free music streaming. Eligible new subscribers can start with a free trial.

Try Music Unlimited free
Prime for Young Adults

A Prime membership for ages 18-24 with a trial period. Eligibility is set by Amazon.

See Prime for Young Adults
Audible

Audiobooks and podcasts to listen to on the go. Eligible new members can start with a free trial.

Try Audible free

As an Amazon Associate we earn from qualifying purchases.